Show
Asked by barreda Aug 07, 2011 at 11:46 AM about the 2010 Chevrolet Malibu Question type: Maintenance & Repair Im changing the oil on my malibu 2010 and I can't find the oil filter, where is the location for it.? 2 AnswersIf it's the 2.4L ecotec it is next to the right side of the intake manifold a little below it mounted on the front of the engine block. It is a canister type filter the top of the housing for the filter must be removed and a new oring lubricated and installed. 13 people found this helpful.
This was very helpful as I could not find it anywhere else, being I had never seen an oil fiter upright like this one Don K 1 people found this helpful. Your Answer:Related Questions
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.
1. Getting Started - Prepare for the repair 2. Open the Hood - How to pop the hood and prop it open 3. Find Oil Drain - Locate the oil drain plug underneath the vehicle 4. Drain Oil - Set up the workspace, drain oil and replace plug 5. Find Oil Filter - Locate the oil filter 6. Remove Filter - Position drain pan and remove the oil filter 7. Replace Filter - Add oil to the new oil filter and insert it 8. Remove Oil Cap - Take off the oil fill cap 9. Add Oil - Determine the correct oil type and add oil 10. Replace Cap - Put the oil fill cap back on the engine 11. Leak Inspection - Start vehicle and visually inspect for leaks 12. Remove Dipstick - Locate, remove and wipe oil dipstick 13. Read Oil Level - Reinsert dipstick, remove and then read oil level 14. Clean Up Tips - How to best clean spills and deal with used oil 15. More Info. - Additional information on oil changes Share on 
This video shows you how to change the oil and oil filter in your 2010 Chevrolet Malibu. When you change your own oil, you know that you are putting quality oil in your Malibu and that the filter is being changed too. Most importantly, you get a chance to look around under your Malibu for potential trouble spots. This video shows you the location of your oil drain plug, oil filter, oil fill cap and dipstick in addition to the steps needed to change the oil and filter in your Malibu. For most Chevrolets, you can wrap an old belt around the oil filter and unscrew it by hand. If you can't do this, see our parts page to find a Chevrolet Malibu oil filter wrench. If your Malibu is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Malibu. Most Chevrolets have the oil type printed on the oil cap - it will likely be 5W-20, 5W-30, 5W-40, 10W-30 or 10W-40. If it isn't printed on the oil cap, check your owners manual for the exact type before adding new oil. We recommend wearing safety glasses whenever you are working under your Malibu. You never know what could be dripping down from the engine, battery acid, engine coolant, brake fluid, etc. All of these fluids are extremely harmful to your eyes and skin so it is important to protect yourself.
Hans Angermeier is an ASE certified Maintenance and Light Repair Technician and has produced over 100,000 videos showing drivers how to fix things on their cars. He has broad expertise on basic repair procedures covering the majority of cars on the road. Over the past 10 years, Hans has been focused on building CarCareKiosk, which is visited by millions of drivers each month. Small bulbs that burn out regularly - did you know you can replace these with LED lights? Don't be the guy with your third brake light burnt out Don't be caught in the fog with burnt out fog light bulbs Your coolant should perform well under any condition - just like Aaron Rodgers! |
Where is the oil filter on a 2010 chevy malibu
Related Posts
Copyright © 2024 moicapnhap Inc.
