Bissell powerforce helix powerful cleaning never loses suction

My PowerForce® Bagless Vacuum has no/low suction | Support

Model #'s 6579, 6582, 6583, 6584, 6585, 6594, 6596 PowerForce Bagless

• Unplug machine
• Slide the Dirt Tank Lever to the left and pull out the Dirt Tank and Filter Cup

• Locate Motor Duct where the base of the dirt cup rested before it was removed
  • Plug machine in, and turn on to feel for suction near the Motor Duct,
    • If there is suction, shut off machine and unplug
    • If there is no suction, shut off machine and unplug then visit a BISSELL Authorized Service Center or Contact Us

• Empty Dirt Tank
• Twist the Filter Cup to the left to remove it from the Dirt Tank

• Twist the Pre-Motor Filter to the left to remove it from the Filter Cup
  • This filter can be washed in warm water with a mild detergent
  • Allow to completely air dry before replacing in machine

• Remove the cyclone in the upper dirt tank by twisting it to the left
  • The cyclone can be cleaned with warm water
  • Allow to completely air dry before replacing in machine

• The Post Motor Filter (PowerForce Turbo Models only) is behind a filter door located under the Lock ‘n Seal Lever 
• Squeeze the Filter Door clip on the right to remove the door and filter
  • The filter can be tapped against a waste bin to remove built up dust and debris
  • This filter is NOT washable

• Remove the Upholstery Hose by untwisting from back of machine and pulling out of lower hose
  • Run a broom handle through hose to remove any clogs
  • If the hose is cracked or damaged it will need to be replaced
• Remove the screw on left of lower hose and lay it flat
  • Run a broom handle through lower hose to remove any clogs

• With machine unplugged, recline the handle and turn the machine so the bottom is facing up
• Press in on the three release tabs behind the brush to remove the Brush Access Plate

• Check the brush and belt for any signs of damage
  • The brush should be able to spin freely by hand
  • The belt should be intact, wrapped around the brush and the metal motor pulley
  • If the part is damaged, it will need to be replaced

• If the machine continues to experience low or no suction, visit a BISSELL Authorized Service Center or Contact Us

Was this answer helpful?